Production of hydrogen by steam gasification of dehydrochlorinated poly(vinyl chloride) or activated carbon in the presence of various alkali compounds

Steam gasification of dehydrochlorinated poly(vinyl chloride) (PVC) or activated carbon was carried out in the presence of various alkali compounds at 3.0 MPa and 560°C–660°C in a batch reactor or in a semi-batch reactor with a flow of nitrogen and steam. Hydrogen and sodium carbonate were the main products, and methane and carbon dioxide were the minor products. Yields of hydrogen were high in the presence of sodium hydroxide and potassium hydroxide. The acceleration effect of the alkali compounds on the gasification reaction was as follows: KOH > NaOH > Ca(OH)₂ > Na₂CO₃. The rate of gasification increased with increasing partial steam pressure and NaOH/C molar ratio. However, the rate became saturated at a molar ratio of NaOH/C greater than 2.0.     

臭氧-生物活性炭深度处理黄浦江水源水中试研究

以黄浦江水源水厂的滤后水为试验对象，进行饮用水O3-BAC深度处理工艺影响因素的中试研完。针对进水水质的试验结果表明，最优臭氧投加量为3mg／L左右，空床停留时间为15min左右。试验结果可为工程设计提供有益的参考。     

青藏铁路用空气弹簧橡胶胶料耐紫外线老化试验研究

我国正在建设的青藏铁路是世界上海拔最高、线路最长的高原铁路.其气候特点对橡胶制品提出了新的技术要求,为适应在该气候条件下的运用需要,进行了针对空气弹簧胶囊用橡胶的耐紫外线老化试验研究工作,试验表明随着紫外线老化时间的增加,其硬度和300%定伸强度均提高,但拉伸强度和扯断伸长率随着紫外线老化时间的增加而降低;通过与胶料的耐臭氧试验和大气老化试验比较,基本可以认为引起空气弹簧胶囊表面龟裂的主要原因是受力状况、臭氧和大气老化的作用,而紫外线对橡胶的表面龟裂影响作用不大,因此,为提高空气弹簧胶囊的耐老化性能,主要考虑降低橡胶的受力,提高耐臭氧和耐大气老化性能.     

生物净化挥发性有机化合物(VOCs)的研究进展

有机废气中大多含有低浓度的苯、甲苯、苯乙烯、多环芳烃等挥发性有机化合物(VOCs)。这类挥发性有机化合物会对人体健康和生态环境造成危害。治理VOCs污染是大气污染治理的重要部分。生物法处理有机废气具有运行费用低、没有二次污染等优点。常用的生物处理技术主要有生物过滤池、生物滴滤池和生物洗涤塔。20世纪80年代生物法在欧洲得到快速发展,我国于90年代以后也开始了生物处理VOCs废气的研究,并取得了一定的成就。     

The GaNE programme in a global perspective

This paper provides the background to this special issue, outlining the extent to which the global atmospheric nitrogen cycle has been modified by human activity and outlining the range of effects. The global total emissions of reduced and oxidized nitrogen, amount to 124 Tg N, and exceed those from natural sources (34 Tg N) by almost a factor of four showing the extent to which anthropogenic activity has taken over the global N cycle. Of the 124 Tg N, 70 Tg N is emitted in the oxidized form, largely as NO and 70% of which results directly from anthropogenic activity. The remaining 54 Tg N is emitted as NH₃, (66% anthropogenic). The enhanced nitrogen emissions are associated with a range of local, regional and global issues including, acidification, eutrophication, climate change, human health and tropospheric O₃. The paper also places the Global Nitrogen Enrichment (GaNE) research programme in the UK in a wider perspective.     

低浓度臭氧在含钴盐硅胶上的吸附研究

常压下对含钴盐硅胶进行低浓度臭氧的吸附实验，吸附达到饱和后用氮气作为载气加热解吸。结果显示，含钴盐的硅胶对臭氧具有较强的吸附能力；臭氧解吸量随着解吸温度的上升而增加；吸附了臭氧的含钴硅胶粒子在常温(313．15K)下可在60min内不问断解吸出臭氧。     

固相萃取-高效液相色谱法测地表水中11种酚类化合物

建立了固相萃取-高效液相色谱法同时测定地表水中11种酚类化合物的方法。水样经过全自动固相萃取仪富集,以HLB柱为萃取柱,乙腈(含1%乙酸)为洗脱剂,用高效液相色谱仪分析定量。该方法在0.5~5.0 mg/L范围内线性良好,相关系数为0.999 6~0.999 9,11种酚类化合物的纯水加标回收率为82.0%~111%,地表水加标回收率为98.5%~116%,精密度为3.58%~4.67%,检出限为1×10-4~5×10-4mg/L,该方法简单实用、准确可靠,可用于地表水中酚类化合物的同时测定。     

Mn/γ-Al2O3催化剂的制备及头孢合成废水的催化臭氧氧化法深度处理

对Mn/γ-Al₂O₃催化剂的制备条件及头孢合成废水的催化臭氧氧化法深度处理工艺条件进行了优化。实验结果表明：以Mn（NO₃）₂溶液为浸渍液，Mn/γ-Al₂O₃催化剂的最优制备条件为浸渍液浓度0.10 mol/L、浸渍时间9 h、焙烧温度400 ℃、焙烧时间2 h;在反应时间为30 min、废水pH为9.0、臭氧通量为4.6 mg/min、催化剂加入量为5 g/L的条件下，当进水COD、BOD₅、ρ（氨氮）和色度分别为220~250 mg/L，8~10 mg/L，10~12 mg/L和60~70倍时，出水COD、BOD₅、ρ（氨氮）和色度的平均去除率分别为53%，30%，33%和93%，出水水质满足GB 21904—2008《化学合成类制药工业水污染物排放标准》的要求。     

海口市臭氧污染特征

基于2013—2015年海口市4个空气质量自动监测站点数据,结合气象资料,分析了海口市O_3的污染特征。结果表明:海口市O_3总体优良,优良天数比例为99.4%,污染天数均为轻度污染;在良和污染天数中,O_3作为首要污染物的天数占40%,超过其他5项污染物占比。海口市10月O_3浓度最高。O_3月均浓度与温度呈负相关关系,同时与风向有密切关系:5—8月气温较高,以南风为主,O_3浓度较低;1月北风频率较高,易受外来污染传输作用,O_3浓度相对较高。O_3超标日以东北风为主,日变化并未呈现单峰型特征,12:00—22:00时段O_3浓度在10%范围内小幅变化。台风外围型和北方冷高压底部型是造成海口市O_3超标的2类典型天气形势。     

Hydrothermal liquefaction phase behavior of microalgae & model compounds in fused silica capillary reactor

A fused silica capillary reactor combined with a heating/cooling stage, a microscope and a digital camera were used to investigate phase behavior during the hydrothermal liquefaction of microalgae (Dunaliella tertiolecta) and model compounds, including soya protein and glycine, starch, glucose and xylose, stearic acid and palmitic acid. Bubbles were generated at 246°C and disappeared at 360°C upon heating when Dunaliella tertiolecta used as feedstocks. Moreover, liquid products were generated at 300°C upon heating and oily liquid products began to separate out at 250°C upon cooling. The phase behavior of soya protein was similar to that of the Dunaliella tertiolecta. Meanwhile, there only observed the bubbles generation during hydrothermal liquefaction of glycine. Heating the starch, glucose and xylose above 350°C generated black solids from carbonization. Stearic acid and palmitic acid only had the process of melting, dissolution, dispersion and precipitation.